Insinger Commander 18-5 Manuel d'utilisateur télécharger pdf (Page 22)

Door Type Series DOC COM 1.0 06

www.insingermachine.com 800-344-4802

Cycle Timers

If your machine is controlled by timing boards instead

of a PLC, timing boards are used to determine wash

time, rinse time and dwell time.

See drawing SK-3490, item no. 8. The potentiometer

control – see below – increases or decreases the

sequence time. Turn the potentiometer with a small

slotted screwdriver clockwise to increase time and

counterclockwise to decrease time.

PART 3 MAINTENANCE & REPAIR PROCEDURES

The board labeled with a ‘W” is for the wash cycle,

the ‘R’ represents the rinse cycle, and the ‘L’

stands for the dwell cycle – the time at the end of

the wash cycle where the amber light is on for a

few seconds to ensure the dishes are sanitized and

to prevent dishmachine operators from getting

splashed with water still flinging off the wash and

rinse arms at the end of the cycle. Do not open the

machine before the light goes out.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 54 55

Pas de commentaire

Insinger Commander 18-5 Manuel d'utilisateur Page 22